Baroness LM3210A, Owner'S Operating Manual, Page: 75 / 167

<Parked regeneration>
These are the conditions for activating
parked regeneration.
The parking brake is applied.
The traveling pedal is in neutral.
The throttle opening is 0% (idling).
The DPF auto regeneration inhibit
switch is set to the "Auto regeneration
mode". (Auto regeneration inhibit icon
disappears.)
The blinking regeneration icon appears.
When the DPF auto regeneration inhibit
switch set to the "Auto regeneration
mode":
1
65 C 55 %
2400 RPM 100 %
% SOOT ENG RPM
FUEL LEVEL COOL TEMP
xlfvcz-004
Level 1_003
1 Regeneration icon
When the DPF auto regeneration inhibit
switch set to the "Auto regeneration inhibit
mode":
65 C 40 %
2400 RPM 100 %
% SOOT ENG RPM
FUEL LEVEL COOL TEMP
1
27gtuu-008
Level 1_004
1 Regeneration icon
Stop traveling and cutting work.
Park this machine in a safe location.
Apply the parking brake.
Set the throttle opening to 0% (idling).
･
1.
2.
3.
4.
1.
2.
3.
4.
5.
Press the DPF parked regeneration
switch.
Parked regeneration starts and the
regeneration icon changes from blinking to
lighting.
When the regeneration completed, the
regeneration icon disappears.
Level 2
Danger Danger
Since it will become extremely hot around the
exhaust outlet during DPF regeneration, do
not perform the regeneration in a location
where fires may occur.
Caution
Normally, set the DPF auto regeneration
inhibit switch to the "Auto regeneration mode".
However, when operating in a location where
fires may occur, set the DPF auto
regeneration inhibit switch to the "Auto
regeneration inhibit mode".
Important
When the system enters the level where DPF
regeneration is required, perform the
regeneration immediately.
Interrupting the regeneration or ignoring the
warning and continuing traveling or cutting
work may cause the engine and DPF to
malfunction.
Important
If ignoring the parked regeneration
requirement and continuing traveling or cutting
work in PM accumulation "Level 2", PM
accumulation level enters "Level 3".
You can continue to use this machine for
traveling and cutting work during DPF auto
regeneration.
You can not continue to use this machine
for traveling and cutting work during DPF
parked regeneration.
You can operate this machine to perform
the regeneration. (The fault diagnostic tool
is not required.)
6.
7.
￭
･
･
･
Description of Functions
LM3210A
Description of Functions
Page 4-39
Engine