Baroness LM3210A, Owner'S Operating Manual, Page: 74 / 167

PM Accumulation Level
Level 0
DPF regeneration is not necessary.
Level 1
Danger Danger
Since it will become extremely hot around the
exhaust outlet during DPF regeneration, do
not perform the regeneration in a location
where fires may occur.
Caution
Normally, set the DPF auto regeneration
inhibit switch to the "Auto regeneration mode".
However, when operating in a location where
fires may occur, set the DPF auto
regeneration inhibit switch to the "Auto
regeneration inhibit mode".
Important
When the system enters the level where DPF
regeneration is required, perform the
regeneration immediately.
Interrupting the regeneration or ignoring the
warning and continuing traveling or cutting
work may cause the engine and DPF to
malfunction.
Important
If the regeneration remains uncompleted even
after 30 minutes have passed since the start
of automatic regeneration in PM accumulation
"Level 1", PM accumulation level enters
"Level 2".
You can continue to use this machine for
traveling and cutting work during DPF auto
regeneration.
You cannot continue to use this machine
for traveling and cutting work during DPF
parked regeneration.
You can operate this machine to perform
the regeneration. (The fault diagnostic tool
is not required.)
￭
￭
･
･
･
<Automatic regeneration>
■
When the DPF auto regeneration inhibit
switch set to the "Auto regeneration mode":
When the conditions for automatic
regeneration are met, the automatic
regeneration starts with the regeneration
icon lighting.
When the regeneration completed, the
regeneration icon disappears.
1
65 C 55 %
2400 RPM 100 %
% SOOT ENG RPM
FUEL LEVEL COOL TEMP
xlfvcz-004
Level 1_001
1 Regeneration icon
■
When the DPF auto regeneration inhibit
switch set to the "Auto regeneration inhibit
mode":
The blinking regeneration icon appears.
Set the DPF auto regeneration inhibit
switch to the "Auto regeneration mode".
When the conditions for automatic
regeneration are met, the automatic
regeneration starts and the regeneration
icon changes from blinking to lighting.
When the regeneration completed, the
regeneration icon disappears.
65 C 40 %
2400 RPM 100 %
% SOOT ENG RPM
FUEL LEVEL COOL TEMP
1
27gtuu-008
Level 1_002
1 Regeneration icon
1.
2.
1.
2.
3.
4.
LM3210A
Description of Functions
Page 4-38
Engine