Baroness LM3210A, Owner'S Operating Manual, Page: 137 / 167

Reduce the clearance by loosening the lock
nut, then tightening the adjustment nut.
Tighten the adjustment nut until the friction
material contacts the friction surface of the
disc.
2
3
4
1
nfzln9-011
Adjustment of Brake_003
1 Brake disc
2 Wire
3 Adjustment nut
4 Lock nut
Warning
A clearance between the brake disc and the
pad that is too small may result in heat
generation or fire.
Loosen the adjustment nut to adjust the
clearance between the brake disc and the
pad to about 0.2 mm (0.0079 in).
Securely place the jack beneath the jack-up
point of the front left/right frame area, and
then raise it until both tires lift off the ground.
Check that the disc rotates freely.
Tighten the lock nut, and then fully tighten it
while holding the adjustment nut in place.
With the brake pedal released, obtain a play
of 1.0 mm (0.039 in) at the connection of the
inner wire.
1
2
3
4
A
nfzln9-026
Adjustment of Brake_004
2.
3.
4.
5.
6.
7.
1 Inner wire
2 Adjustment bolt
3 Lock nut
4 Connection
A 1.0 mm (0.039 in)
Use a wrench to loosen the lock nut and
tighten it after making the adjustment with
the adjustment bolt.
Drive, and then check the following.
Make sure that heat is not generated in
the brake area.
Make sure that the left and right brakes
are equally effective.
Caution
It may result in an unexpected accident if the
left and right brakes are not equally effective.
If the left and right brakes are not equally
effective, make fine adjustments with the
adjustment bolt on the brake wire.
1
nfzln9-012
Adjustment of Brake_005
1 Adjustment bolt (on brake disc side)
Break-In of Brakes
If the brake shoes or brake pads are worn,
replace them with new ones.
Immediately after replacement, drive to break
in the brakes if the effectiveness of the brakes
is low.
While driving, lightly operate the brakes to
break in the contact areas.
8.
9.
･
･
10.
Repair
LM3210A
Repair
Page 7-3
Adjustment and Replacement