Baroness LM3210A, Owner'S Operating Manual, Page: 126 / 167

Be sure to tighten the bolts A and B
securely after adjustment.
1
2
3
4
5
A
B
0E85A5FE
Adjustment of Fan Belt_002
1 Fan belt
2 Blade
3 Alternator
4 Bolt A
5 Bolt B
A Measurement position
B Distance between pulleys
Adjustment of CR Brush Drive Belt
Note:
Depending on the specifications, this function
may not be available.
Remove the belt cover.
Check the belt tension.
The belt tension is appropriate when the
belt slacks by approximately 5.0 to 6.0 mm
(0.197 to 0.236 in) when you apply a force
of 10.0 N (1.0 kgf) with your finger to the
belt at the middle point between the
pulleys.
If the belt tension is inappropriate, adjust
the belt tension with the tension pulley
adjustment bolt.
2
1
4g49yh-001
Adjustment of CR Brush Drive Belt_001
[3]
1.
2.
3.
1 Tension pulley adjustment bolt
2 Belt
Change of Coolant
Caution
Do not touch the radiator or coolant during
engine operation or immediately after the
engine has been turned off.
Otherwise, you may get burned.
Caution
Change coolant after the engine has well
cooled down.
Caution
The radiator cap is pressurized.
If you remove the radiator cap while the
engine is overheated, hot steam will burst out,
possibly resulting in burns.
Make sure that the water temperature and
pressure are reduced, and then grab the cap
with a thick cloth and gradually open the cap.
Important
When changing the coolant, be sure to drain it
into a container and discard it in accordance
with local laws and regulations.
Important
When changing the coolant, be sure to mix
clean water and antifreeze (long-life coolant),
and then pour it into the radiator and reserve
tank.
Important
Tightly close the radiator cap.
If the cap is loose or incorrectly installed, the
engine will be overheated due to water
leakage, resulting in engine damage.
When mixing antifreeze and clean water, refer
to "Relationship between concentration of long-
life coolant (LLC) and freezing temperature"
below for the mixing ratio.
Relationship between concentration of long-life
coolant (LLC) and freezing temperature
LM3210A
Maintenance
Page 6-26
Adjustment and Replacement