Attach the reel cutter (cutting cylinder) to the
frame like the figure below.
Tighten the inner nut and check the bearing
for backlash.
Loosen the inner nut at the level that the reel
cutter (cutting cylinder) can be rotated lightly
by your hand and you don't feel the
backlash.
Tightening torque: 7 N-m (71.4 kgf-cm /
61.96 lb-in)
Tighten the outer locknut.
4
3
5
1
1
8
2
7
6
wggg9e_001
Attaching Reel Cutter (Cutting Cylinder)_001
1
Bearing
2
Seal
3
Reel cutter (Cutting cylinder)
4
Inner nut
5
Outer nut
6
Key
7
Cover
8
Pin
Maintenance (Main Body)
Removing/Installing Tires
Front Tire
Follow the steps below to remove the front tire:
Loosen the bolts.
1
lm2ieh-004
Front Tires_001
2.
3.
4.
5.
1.
1
Heat-treated bolt
Securely place the jack beneath the jack-up
point of the front right/left frame area, and
then raise it until the tire lifts off the ground.
(See "Jack-up Points" (Page 5-5) .)
Remove the bolts.
Remove the tire from the wheel mounting
base.
Caution
Refer to the Tightening Torque Table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the front tires, reverse the
removing procedure.
Rear Tire
Follow the steps below to remove the rear
tires:
[2WD]
Securely place the jack beneath the jack-up
points of the engine mount frame area, and
then raise it until the tire lifts off the ground.
(See "Jack-up Points" (Page 5-5) .)
Remove the wire.
Remove the right/left bolts.
Remove the rear wheel Assy.
2
1
3
75uxaw-005
Rear Tires_001
1
Wire
2
Bolt
3
Rear wheel Assy
2.
3.
4.
1.
2.
3.
4.
Maintenance
LM315GC
Maintenance
Page 5-11
Maintenance (Main Body)
Summary of Contents for LM315GG
