Baroness LM315GG, Owner'S Operating Manual

Page: 52 / 75

Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the lamp
is turned off after a specified amount of time
passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
1
q44uug-002
Thermo-start Lamp_001
1 Thermo-start lamp
Oil Pressure Lamp
The oil pressure lamp is the right pilot lamp
located in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and engine oil
pressure is generated properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately, and
then inspect the machine and perform any
necessary maintenance.
1
1ldikn-002
Oil Pressure Lamp_001
1 Oil pressure lamp
Fuel Gauge
The fuel gauge is located on the fuel tank.
This instrument indicates the quantity of fuel
inside the fuel tank.
1
96ltfa-004
Fuel Gauge_001
1 Fuel gauge
Travel of Machine
Moving the Machine
Start the engine.(See "Procedure to Start
Engine" (Page 4-21) .)
Raise all mower units.
While pressing the push button, release the
parking brake lever.
Slowly depress the traveling pedal.
The machine can start traveling.
Towing the Machine
If the machine does not travel due to engine
trouble, etc., you can move it in the following
ways:
Pushing by hand
Towing (See the following instruction.)
Caution
Tow the machine at a low speed while paying
close attention.
Caution
Do not touch the unload valve except when
towing the machine.
Caution
Before restarting the engine, be sure to close
the unload valve.
1.
2.
3.
4.
5.
･
･
LM315GC
Handling Instructions
Page 4-32 Travel of Machine