Baroness LM315GG, Owner'S Operating Manual

Page: 48 / 75

1 Reel Rotation Switch
A ON
B OFF
When the reel rotation switch turns "ON," the
rotation of the reel cutter (cutting cylinder)
operates simultaneously with the up/down of the
mower unit. If the mower unit is going down, it
rotates and if the mower unit is going up, it
stops.
When the mower unit is going down, the
sensor activates the electromagnetic clutch
and the reel cutter (cutting cylinder) starts
rotating by the flexible wire.
When the mower unit is going up, even if the
reel rotation switch is at "ON" status, the
sensor does not activate the electromagnetic
clutch and the reel cutter (cutting cylinder)
does not rotate.
Important
When the reel rotation switch is at "ON," 3WD
is applied regardless of the selection of the
2WD/3WD selector switch.
Reel Reverse Lever
Caution
Operate the reel reverse lever while the
rotation of the reel cutter (cutting cylinder) is
stopped, and adjust it to the position suitable
for your work.
The reel reverse lever is located at the upper
part of the gear case at the left of the mower
unit. If you set the lever to Normal, it starts
cutting rotation, set to Reverse for lapping
rotation and Neutral for free.
1
C
A
B
32w9j9-004
Reel Reverse Lever_001
1.
2.
1 Reel reverse lever
A Normal rotation
B Neutral
C Reverse rotation
Transmission Selector Lever
Caution
The transmission selector lever should be
operated while the engine rotation is stopped,
and adjusted to the position suitable for your
work.
The transmission selector lever is located at the
upper part of the transmission behind the
driver's seat. When shift the lever to "H," the reel
cutter (cutting cylinder) rotate fast, "L" makes
slow and "LAP" makes slower suitable speed for
back lapping.
1
2
3
zzpqiy-002
Transmission Selector Lever_001
1 H
2 L
3 LAP
H
The reel cutter (cutting cylinder) rotates
faster and the clip pitch (cutting interval)
becomes shorter.
This is suitable for the work at a good turf
condition.
L
The reel cutter (cutting cylinder) rotates
slower compared to when it is at "H" and the
clip pitch becomes longer.
This is suitable for the work at the turf
condition not so good. 1.
2.
LM315GC
Handling Instructions
Page 4-28 Operation of Each Section