Service Mode
8-23
5976194 BARCOCINE 9 31012002
How to change the position ?
To change the position :
1. Push the cursor key
é
or
ê
to highlight 'Menu position' (menu 1).
2. Press ENTER to toggle between STANDARD or MIDDLE.
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
COMMON SETTINGS
menu 1
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION :
STANDARD
I2C Diagnostics
What can be seen ?
The I2C diagnostics menu gives an overview of the I2C failures inside the projector.
To scroll through the failure list, push the cursor key
é
or
ê
.
The I2C address, IC number and module name will be given in I2C diagnostic menu.
When no errors are detected, the following message will appear on the screen :
"No errors on i2c-bus detected".
How to select ?
1. Push the cursor key
é
or
ê
to highlight 'I²C Diagnostics' (menu 1).
2. Press ENTER to display the diagnostic menu (menu 2).
Scroll with or
then <ENTER>
<EXIT> to return.
I2C DIAGNOSTICS
Failures :
addr IC number mod.name
48H
IC200
DECODER
menu 2
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
SERVICE MODE
menu 1
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Voltage Diagnostics
What can be seen ?
The real value of the different voltages will be displayed on the voltage diagnostics menu.
How to start up ?
1.
Push the cursor key
é
or
ê
to highlight 'Voltage diagnostics' (menu 1).
2.
Press ENTER to display the voltage diagnostic menu (menu 2).
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
SERVICE MODE
menu 1
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
<EXIT> to return.
VOLTAGE DIAGNOSTICS
menu 2
+17V :
16.9 Volt
-17V
:
-17.1 Volt
+9V
:
+9 Volt
+12V :
+11.9 Volt
-12V
:
-11.8 Volt
+30V :
+29.8 Volt
-40V
:
-39.8 Volt
+110V :
+110 Volt
+210V :
+209 Volt
HTHD :
-conv :
+conv :
foc_lo :
foc_hi :