Service Mode
8-22
5976194 BARCOCINE 9 31012002
How to create a new memory bank ?
1.
Select your source. The projector selects the last used memory bank.
2.
Press ENTER
3.
Push the corresponding digit (between 1 and 8) of a non existing memory bank. (The memory banks can be created in random
order, e.g. first creating bank 5 and later bank 2.)
4.
Make the necessary adjustments. When leaving the source, the new created memory bank will be saved for later use.
Example : When source 1, video 15.6 kHz /60Hz is create on bank 4 and the vertical frequency changes to 50Hz, the projector will
create a new block (due to the vertical frequency change) with the same bank number 4.
How to recall a specific memorybank for the actual source ?
When the memory bank option is ON and a source is selected, this source will be displayed with the last used memory bank settings.
An on-screen menu will give a indication of the memory bank nummer used (menu 1).
To switch to another memory bank :
1.
Press ENTER to select the next memory bank in increasing order.
or
2.
Enter the number of the desired memory bank with the digit keys.
In both cases, the on-screen indication will be update.
SOURCE XX
MEMORY
BANK
4
menu 1
Flyback Turnover Point
What can be done ?
The horizontal flyback time for horizontal frequencies can be long or short. The turnover point from long to short can be installed
by the user himself.
Set Up of the Flyback Turnover Point
To set up the flyback turnover point :
1.
Push the cursor key
é
or
ê
to highlight 'Flyback turnover point' (menu 1).
2.
Press ENTER to display the flyback turnover point (menu 2).
The actual turnover point frequency will be filled in.
3.
Select the digits with the left or right cursor keys and enter the new value with the digit keys on the RCU.
The flyback turnover point frequency should be somewhere between 90 kHz and 130 kHz.
4.
Press ENTER to select.
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
COMMON SETTINGS
menu 1
DYNAMIC ASTIGMATISM
GAMMA CORRECTIONS
CRT RUN IN CYCLE
CRT DRIVE MODE
MEMORYBANKS : ON
FLYBACK TURNOVER POINT
MENU POSITION : STANDARD
Menu Position
What can be done ?
The bar scale menu, warning and message boxes can be displayed in the right lower corner or in the middle of the screen.
<ENTER> to confirm
<EXIT> to return.
FLYBACK TURNOVER POINT
menu 2
Enter new frequency :
0 9 0 kHz
Use the
ç
or
è
to select,
and reprogram with
numeric keys
Lowest point is 90 kHz.
Highest point is 130 kHz.