Service Mode
8-2
5976194 BARCOCINE 9 31012002
Projector Set-up
What can be done ?
Within the projector set-up menu, the following items can be consultated or set to the
desired setting :
- Identification
- Total run time
- Change password
- Change projector address
- Change baudrate
- Projector warm up
- Power up mode
- Common address
Start up the Projector Set-Up
To select Projector Set-Up :
1.
Push the cursor key
é
or
ê
to highlight Projector Set Up (menu 1).
2.
Press ENTER to display the Projector set up menu (menu 2).
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0
menu 1
menu 2
Identification
What can be seen ?
The 'Identification' screen gives information concerning :
- Projector address. To change the address of your projector, contact a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be
the same as the baud rate of the connected computer. When there is a difference, contact a qualified service technician to make
the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be displayed and if warnings and failures will be dis-
played.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.
- Projector Level : from 0 to 6. The higher the level the more software options installed. Contact your vendor for more information.