Service Mode
8-4
5976194 BARCOCINE 9 31012002
Change Projector Address
What can be done ?
Every projector requires an individual address between O and 255. This address can be software installed.
How to change that address ?
To change that address, handle as follow :
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use
ç
and
è
to select,
and reprogram
with numeric keys.
Highest address is 255
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0
menu 1
menu 2
Change password
What can be done ?
The password code (4 digits) can be changed to a new one.
This item is password protected. First the actual password should be entered before continuing.
Note
Password function is only active if the jumper on the controller is in the 'ON' position.
How to select ?
To select Change Password :
1.
Push the cursor key
é
or
ê
to highlight 'Change Password' (menu 1).
2.
Press ENTER to display the password menu (menu 2).
If it is the first time you enter a password protected item, enter your password and press ENTER.
The current password is displayed. The new password must consist of 4 digits between 0 and 9.
How to enter a new password ?
Handle as follow :
1.
Push the cursor key
ç
or
è
to select the digits to be changed (menu 2).
2.
Press a numeric keys to enter the new digit.
3.
Repeat for the other digits.
4.
Press ENTER to save the new password.
Before saving the new password, a confirmation screen will be displayed (menu 3).
5.
When the displayed password is correct, press ENTER to save.
6.
If not correct, press EXIT to cancel the saving.
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
CHANGE PASSWORD
Select with
é
or
ê
then <ENTER>
<EXIT> to return.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0
Use
ç
and
è
to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
PASSWORD
Enter new password :
0 0 0 0
menu 1
menu 2
menu 3
1.
Push the cursor key
é
or
ê
to highlight 'Change Projector Address' (menu 1).
2.
Press ENTER to select.
The Change Projector Address menu (menu 2) will be displayed and the actual address will be filled in. The first digit is highlighted.
3.
Push the cursor key
ç
or
è
to select the digit to be changed.
4.
Reprogram with the digit keys on the RCU.
5.
Press ENTER to confirm.