First installation
33
This is the MediCal Pro configuration corresponding to the medical viewing station shown above.
To run Q/A tasks on the viewing station or to perform actions on the
viewing station displays, MediCal Pro must know the exact and complete
configuration.
The first time MediCal Pro is run, the user must put the configuration into
the program if the displays were not added to the configuration during
startup.
Setting up the configuration can be done easily in two ways:
- Using the Configuration Setup Wizard, which will guide you through
the setup process.
- Adding the displays or projector(s) directly, by right-clicking on the
icons of the imaging board heads and selecting Add Display from the
drop-down menu.
An optical sensor built in or connected to the displays or viewing station,
will be added to the configuration automatically when you start a task
that requires a sensor.
Setting up the configuration by running the Configuration Setup Wizard
To start the Configuration Setup Wizard, click on the Configuration Setup...
button in the main window. As a result, the Wizard starts.
The Wizard will guide you through the following steps:
Summary of Contents for MediCal Pro
