Barco F400, User Manual

Page: 116 / 220

R5915525 /00 Fx400 Series 116
• Sync Delay : You can increase or decrease the sync delay. The scale goes from –10 000 µs to +10 000 µs
with a step of 100 µs.
Choosing the desired output mode
The following output modes are available:
• AutoStereo : Automatic mode (2D input = 2D output, 3D input = Active Stereo output).
• Mono : Forces all source signals to 2D output.
• ActiveStereo : Forces all source signals to Active Stereoscopic 3D.
Use the following table as an indicator of what display mode you require.
Source signal
AutoStereo Mono ActiveStereo
2D Source Output is a 2D image Output is a 2D image Output is in Active Stereo
Active Stereo source Output is in Active Stereo Output is a 2D image Output is in Active Stereo
Passive Stereo source Output is in Active Stereo Output is a 2D image Output is in Active Stereo
When a different Display Mode is chosen compared to the source signal (e.g. Active Stereo source
with Mono output), advanced image processing will make sure you a desirable image will be
displayed.
If a 3D emitter is used that radiates infrared beams (IR beams), the IR beams may interfere with the
IR communication between projector and the RCU. If such interference occurs, connect the RCU to
the projector using the remote cable. It is also advised to turn the IR receivers on the projector off to
avoid the 3D emitter interference. To turn off the IR receivers, see
“Pulse RCU, function of the on/off
button”, page 29 .
How to adjust the projector to the 3D emitter?
1. In the main menu, select Installation → 3D Setup .
Image 8–76 Installation menu, 3D setup
The 3D setup menu is displayed.
Image 8–77 Example of the 3D setup menu on a UDX
2. If it is necessary to invert the stereo sync output, enable the Swap eyes option.
GUI – Installation