Barco DML-1200, User Manual

Page: 10 / 113

1. Safety
On servicing
• Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage potentials
and risk of electric shock.
• Refer all servicing to quali fi ed service personnel.
• Fence off a restricted area of at least 3 meters around the projector using an eye-catching fence and “KEEP OUT” signs. This
to prevent unauthorized persons coming near the projector during servicing.
• Unplug this product from the wall outlet and refer servicing to quali fi ed service technicians under the following conditions:
- When the power cord or plug is damaged or frayed.
- If liquid has been spilled into the equipment.
- If the product has been exposed to rain or water.
- If the product does not operate normally when the operating instructions are followed. Adjust only those controls that are
covered by the operating instructions since improper adjustment of the other controls may result in damage and will often
require extensive work by a quali
fi ed technician to restore the product to normal operation.
- If the product has been dropped or the cabinet has been damaged.
- If the product exhibits a distinct change in performance, indicating a need for service.
• Replacement parts: When replacement parts are required, be sure the service technician has used original Barco replace-
ment parts. Unauthorized substitutions may result in degraded performance and reliability,
fi re, electric shock or other hazards.
Unauthorized substitutions may void warranty.
• Safety check: Upon completion of any service or repairs to this device, ask the service technician to perform safety checks to
determine that the product is in proper operating condition.
• Lamp replacement: high pressure lamp may explode if improperly handled.
1.3 Important warnings concerning DML fl ight cases
Important warnings concerning stacking/transporting DML rental fl ight cases
• Stack maximum two (2) DML rental fl ight cases high. Never higher.
• The surface on which a fl ight case is standing must be level to ensure that the total load is evenly spread out among the four
wheels. The surface must also be able to support the load safely.
• Before stacking or transporting fl ight cases, check the wheels and their fi xation screws for wear or defects.
• Before stacking or transporting fl ight cases, check that the six lock handles on each fl ight case are in good working order and
locked securely.
• When stacked, make sure the wheels of the upper fl ight case are precisely positioned in the stacking dishes of the fl ight case
below.
• Stacked fl ight cases may not be moved. Before stacking, the lower fl ight case must already be in its fi nal resting position before
placing the second upon it.
• Never stack loaded fl ight cases in a truck or other transport medium, unless each fl ight case is rigidly strapped tight.
• In the event of a wheel breaking, fl ight cases must be rigidly strapped tight to prevent a stack collapsing.
• Use an appropriate forklift to raise fl ight cases and take the necessary precautions to avoid personnel injury.
1.4 Recycling guidelines
W
ARNING
:
Do not break or crush lamps because this may pose health and environmental risks when mercury
vapors are released.
C
AUTION
:
To avoid breaking the lamps, repack carefully when storing and transporting them.
6 R59770208 DML-1200 06/11/2009