Barco DML-1200, User Manual

Page: 19 / 113

3. Physical installation
3.2 Mounting the DML-1200 upright
C
AUTION
:
Always pan and tilt lock the device while handling it.
How to mount
To mount the DML-1200 upright, place the device on a sturdy, stable surface that will support more than 75 kg (165.4 lbs). If the
surface is above
fl oor height, use safety cables to secure the device to the surface.
When mounting on a chariot with wheels, always use wheels with brakes.
Image 3-5
Mounting upright
Restricted Access Location
The DML-1200 must be installed in a Restricted Access Location, where access can only be gained by persons who have been
instructed about the reasons for the restriction applied to the location and about the precautions that shall be taken.
Reasons for the applied restrictions: moving head in all directions, air outlet can reach high temperatures and light output may cause
eye injury when looking directly into the lens.
3.3 Truss mounting of the DML-1200
C
AUTION
:
Verify the truss or support if it can handle the combined weight of all the devices on the truss. If
necessary, consult a structural engineer.
W
ARNING
:
Before mounting, disconnect the power to the DML-1200. If it has been operating, allow to cool
for fi ve minutes before handling.
Rigging points and rigging clamps
Four slots are longitudinally (A) oriented and four slots are transversely (B) oriented. Each slot contains a rigging point of which the
position in the slot can be adjusted depending on the size of the truss installation. The rigging clamps (C) can be attached to those
rigging points, which allows an easy and fast physical setup of the device in a hanging con
fi guration. The 4 corners contains also
each a rigging point as well as 2 fi xed positions in the middle of two sides.
R59770208 DML-1200 06/11/2009 15