CALIBRATION
By a pop-up menu, you can access following calibration functions:
• “ Battery “: Battery reset voltage calibration (Fig. 16) (**)
• “ Timers “: Timers calibration (Fig. 17)
• “ Steering “: Steering sensor (Fig. 18)
• “ Pedal “: Pedal accelerator calibration (Fig. 19) (**)
• “ Lift “: Lift calibration (Fig. 20)
• “ ESH “: E/S/H parameters calibration and limits (Fig. 21, Fig. 22, Fig.
23)
• “ Steering parameters “: Steering parameters calibration (Fig. 24)
• “ Program service “:Program service interval setting (Fig. 25)
• “ Drive motor “: Drive motors parameters calibration (Fig. 26) (**)
• “ Pump motor “: Pump motors parameters calibration (Fig. 27)
• “ Critical height switches “: Speed limits calibration in case of critical
height (Fig. 28)
• “ Weight sensor “: Weight sensor calibration (Fig. 29) (*)
• “ Brake sensor “: Brake sensor calibration (Fig. 30) (*)
• “ Hydro threshold “: Hydro threshold calibration (Fig. 31) (*)
• “ Cab lift “: Cab lift speed calibration (Fig. 32) (*)
• “ Truck setup “: Some lift truck parameters setup (Fig. 33) (*) (**)
• “ Pliers calibration “: Some lift truck parameters setup (Fig. 34) (*)
• “ Backing mode “: Slow mode calibration (Fig. 35) (*)
• “ Timers reset “: Timers meters reset (Fig. 36)
• “ Load eeprom “: EEPROM memory configuration (Fig. 37, Fig.38)
• “ Parameters image” : Lift truck parameters configuration (Fig. 39, Fig.
40)
• “ Hour meter calibration” : Hour meter setting (Fig. 41a, Fig. 41b) (*)
(*): Optional menu
(**): Menu present in standard or optional version
Notice :
some of the parameters listed in test menus are not present in
all applications
Notice:
you can access all calibration menus only if in Supervisor mode
and with park brake on.