7-16 Parameter Descriptions
MN767S
7.4.3 Additional Parameter Group 0 – Monitoring Parameters
Table 7-8 Additional Parameter Group 0 - Monitoring Parameters
Par No.
Description
Range
Units
Default
Explanation
P0-31
Drive Serial Number #2
P0-32
DSP Bootloader Version
E.g. “ 1.00”
P0-33
Measured Cos phi
E.g. 0.78
P0-34
Comms Error Count (DSP)
0 … 65535
P0-35
Configuration Register Value
Internal value
P0-36
Digital Input Status
Internal value
P0-37
Analog Out Internal Value
Internal value
P0-38
Current Phase U Offset
Internal value
P0-39
Current Phase U Ref
Internal value
P0-40
Current Phase V Offset
Internal value
P0-41
Current Phase V Ref
Internal value
P0-42
Brake Resistor Max on Time
Time in milliseconds
P0-43
Brake Resistor Duty Cycle
Internal value
P0-44
Uq Internal Ref Value
Internal value
P0-45
Ud Internal Ref Value
Internal value
P0-46
Measured Spin Start Speed
Internal value
P0-47
Calculated Slip Speed Value
Internal value
(V/F mode only)
P0-48
Hoist Boost Speed
Internal value
P0-49
Rated Iq Internal Value
Internal value
P0-50
Motor Voltage
V ph-ph (rms)
P0-51
Switching Frequency Internal
Internal value
P0-52
Speed Hysteresis Value
Internal value
P0-53
PID DC Bus Feedback Value
0..4096
P0-54
Modbus Comms Error
0 … 65535
P0-55
Modbus Speed Reference
Internal value
P0-56
Droop Speed
Internal value
P0-57
Encoder Speed
-P1-06 to P1-06
Hz / Rpm
Displays
the
encoder
speed
P0-58
Speed Jump Zone
Internal value
P0-59
Modbus Write Command Data Value
Register dependent
P0-60
Motor Control Loop ID
0 … 65535
Summary of Contents for VS1STS Series
