5-6 Control Wiring
MN767S
Notes:
By default, if the enable signal is present the drive will not Enable until the START button is pressed. To auto-
matically enable the drive when the enable signal is present set P2-19 = 2 or 3. This then disables the use of the START &
STOP buttons.
In keypad mode, the speed can be adjusted using the UP & DOWN keys on the built in keypad, or a remote mounted
keypad, in addition to push buttons connected to the digital inputs.
The reverse input only functions under the following conditions:
- P1-07 = 1, P2-19 = 2 or 3. P2-35 must not be 2 or 3.
- P1-07 = 2. P 2-35 must not be 2 or 3.
The external trip input can be used to connect a motor thermistor by connecting between terminals 1 and 4
When P1-07 = 2 , the direction of motor can be reversed by:
- pressing the START button.
- closing the reverse input (When using a setting of P1-08 that includes this function).
- using a negative speed reference (e.g. select a preset speed of -10Hz).
Since all of these functions can be active at once, care must be taken to ensure the motor always turns in the correct
direction.
5.3.3 PI Control Mode (P1-07 = 3)
Table 5-5 Parameter P1-08 Control of Digital Inputs when P1-07 = 3
P1-08
Digital In 1
(Term 2)
Digital In 2
(Term 3)
Digital In 3
(Term 4)
Analog Input 1
(Term 6)
0, 10,
13, 16,
18
Open: Stop
Closed: Run
No Function
Analog Input 2
Bipolar Analog Input 1
11
Open: Stop
Closed: Run
Open: PID control
Closed: Preset Speed 1
External Trip Input
Bipolar Analog Input 1
Open: Trip
Closed: No Trip
12
Open: Stop
Closed: Run
Open: Preset Speed 1
Closed: PID control
External Trip Input
Bipolar Analog Input 1
Open: Trip
Closed: No Trip
17
Open: Stop
Closed: Run
Open: PID control
Closed: Bipolar analog
ref
Analog Input 2
Bipolar Analog Input 1
19
Open: Stop
Closed: Run
Open: PID control
Closed: Analog input 2
Analog Input 2
Bipolar Analog Input 1
20, 21
Open: Stop
Closed: Run
Digital Output:
Drive Healthy = +24V
Analog Input 2
Bipolar Analog Input 1
22
Open: Stop
Closed: Run
Digital Output:
Drive Healthy = +24V
External Trip Input
Bipolar Analog Input 1
Open: Trip
Closed: No Trip
Note:
When P3-05 = 1, Bipolar analog input controls PID set point. The feedback must then be connected to Analog input 2 and
P3-10 must be set to 0 (Default setting). The external trip input only functions when the feedback source is the Bipolar
analog input (P3-10 = 1).
Summary of Contents for VS1STS Series
