INSTALLATION
SETUP/PHYSICAL INSTALLATION
I-E96-401A
2 - 9
round cable (61 meters [200 feet] maximum). The cable is
shielded. To install the cable:
NOTE: If the module is installed, pull it several inches from the back-
plane
before installing the cable.
1. Insert one end of the cable into the module mounting unit
backplane slot assigned to the module. The cable should latch
securely in place. Card edge connector P3 of the module con-
nects to this end of the cable.
2. Connect the shield wire to the shield bus bar.
3. Insert the other end of the cable into the termination
mounting unit (TMU) backplane slot assigned to the IMP termi-
nation module. The cable should latch securely in place. Card
edge connector P3 of the termination module connects to this
end of the cable.
4. Install a cable retaining bracket to the rear of the TMU unit.
Figure 2-10. IMP Termination Module Cable Connections
T00457A
TERMINAL
PRIMARY MODULE
IMMFP01
IMMFP02
IMMPI01
INIIT02
NIMP01
NICS01
SERIAL LINK
NKTM01
NKTU02
NKTU12
P3
COMPUTER
PRINTER
P3
RS-232-C
RS-232-C
NIMP02
P3
NKTM01
NKTU02
NKTU12
NOTE: USED WITH IMM FP03, IMMFP04 AND
INICT03 MODULES.
REDUNDANT MODULE
IMMFP01
IMMFP02
IMMPI01
INIIT02
P5
P6
P7
P1
P11
P16
P9
P10
P3
REDUNDANCY
CABLES
PRINTER
RS-485
TB
22
21
RI
B
B
O
N
CA
B
L
E
66
3
4
40
8
A
2
Summary of Contents for infi 90 NIMP01
Page 2: ......
