INSTALLATION
SETUP/PHYSICAL INSTALLATION
2 - 8
I-E96-401A
®
Do not bundle the ribbon cable with other wiring. Bundling the
cable can cause cross talk in the ribbon cable. To install the
cable:
NOTE: If the module is installed, pull it several inches from the back-
plane
before installing the cable.
1. Insert one end of the cable into the module mounting unit
backplane slot assigned to the module. The cable should latch
securely in place. Card edge connector P3 of the module con-
nects to this end of the cable.
2. Insert the other end of the cable into the termination
mounting unit (TMU) backplane slot assigned to the IMP termi-
nation module. The cable should latch securely in place. Card
edge connector P3 of the termination module connects to this
end of the cable.
NKTU02 AND NKTU12 CABLES
The NKTU02 PVC Termination Cable (KTU) and the NKTU12
Non-PVC Termination Cable (KTU) connect the NIMP01 termi-
nation module to the primary module and the NIMP02 termi-
nation module to the redundant module. The KTU cable is a
Figure 2-9. Jumper Settings for ESA Controls SER-740
RXD
T00456A
RXD-A
TXD-A
TXD
CTS-A
CTS
RTS-A
RTS
DB9-2
DB9-3
DB9-7
DB9-8
J1 AND J2
1
2
3
4
5
6
7
8
9
10
11
12
+12 V
1
2
2
2
1
1
DSR
DCD
DTR
DB9-6
NOTE: JUMPERS J8, J9 AND J10 RELATE TO
THE P6 CO NNECTOR. JUMPERS J5, J6 AND J7
RELATE TO THE P5 CONNECTOR.
J6 AND J8
J5 AND J9
J7 AND J10
DB9-1
DB9-4
DB9-5
1
2
J19 AND J20
Summary of Contents for infi 90 NIMP01
Page 2: ......
