INTRODUCTION
FEATURES
I-E96-401A
1 - 3
The NIMP02 also occupies one slot in the TMU unit. It consists
of:
•
Two 16-pin connector sockets.
•
One DB-9 connector for RS-485 link.
•
Light emitting diode (LED).
•
Terminal blocks.
FEATURES
The NIMP01 termination module has two jumper configurable
RS-232-C ports for DCE or DTE operation, one of which can be
configured as an RS-485 port. The ports allow the MFP module
to talk to a variety of computers and communication equip-
ment. An on-board LED lights when the MFP module con-
nected to the IMP module is the primary module and is on-line.
The termination module also provides two serial communica-
tion links for control stations through the NICS01 and NIDS01
termination modules. These links allow the MFP module to talk
to analog and digital control stations. The NIMP02 module fea-
tures a single LED that illuminates when the redundant MFP
module is active.
INSTRUCTION CONTENT
This manual consists of five sections and five appendices.
Contains an overview of the features, specifications and a
description of the IMP termination module.
Describes precautions to observe when handling modules and
setup procedures required before module operation. This sec-
tion discusses dipswitch settings and installation procedures.
Provides a maintenance schedule.
Details how to replace an IMP termination module.
Describes the support services (spare parts, training, docu-
mentation, etc.) available from Bailey Controls Company.
Appendices
Briefly discuss the modules that use the IMP termination mod-
ule and provide a cross reference of dipswitch and jumper set-
tings for those modules.
HOW TO USE THIS MANUAL
Read this manual through in sequence. Read
thor-
oughly. Do the steps in order. Complete all steps in the section
before using the IMP termination module. Refer to the Table of
Summary of Contents for infi 90 NIMP01
Page 2: ......
