INSTALLATION
UNPACKING AND INSPECTION
2 - 2
I-E96-401A
®
UNPACKING AND INSPECTION
1. Examine the hardware immediately for shipping damage.
2. Notify the nearest Bailey Controls Company sales office of
any such damage.
3. File a claim for any damage with the transportation com-
pany that handled the shipment.
4. Use the original packing material and container to store the
hardware.
5. Store the hardware in an environment of good air quality,
free from temperature and moisture extremes.
SETUP/PHYSICAL INSTALLATION
This section explains how to configure and install the termina-
tion modules. You must set the jumpers before installing the
termination modules. The pin jumpers on the NIMP01 termina-
tion module determine the operation of the RS-232-C ports.
Each port can be configured as a DTE, DCE, nonhandshake or
loopback device. Only port one can terminate to a diagnostic
terminal. The termination module can interface with:
•
Devices:
Printer.
Sequence of events recorder.
IBM
®
PC.
COMPAQ
®
and compatible computers.
•
Terminals:
VT1XX.
ADM3.
VISUAL 50.
WYSE (WY50).
TELEVIDEO.
FALCO.
•
VAXstation™.
Fuse Installation
Fuse F1, a 1.0 amp/250 volt fuse (Bailey part number
194776A11001) is installed in each IMP termination module.
Figure
shows the termination module layout. Verify that
the fuse is installed in fuse holder F1.
® IBM is a registered trademark of International Business Machines Corporation.
® COMPAQ is a registered trademark of COMPAQ Corporation.
™ VAXstation is a trademark of Digital Equipment Corporation.
Summary of Contents for infi 90 NIMP01
Page 2: ......
