Bailey infi 90 NIMP01, Instruction

Page: 23 / 52

INSTALLATION
SETUP/PHYSICAL INSTALLATION
I-E96-401A 2 - 7
Cable Installation
Figure 2-10 shows the cable connections between the modules,
termination modules and output devices. The cable from the
IMP termination module to the control module can be either
the KTU termination module cable (round cable) or the KTM
termination module cable (ribbon cable).
NKTM01 CABLE
This cable connects the NIMP01 termination module to the pri-
mary module and the NIMP02 termination module to the
redundant module. The NKTM01 Termination Module Cable
(KTM) is a flat ribbon cable (30 meters [100 feet] maximum).
Figure 2-8. Jumper Settings for Rochester ISM
RXD
T00455A
RXD-A
TXD-A
TXD
CTS-A
CTS
RTS-A
RTS
DB9-2
DB9-3
DB9-7
DB9-8
J1 AND J2
1 2
3 4
5
6
7 8
9
10 11 12
+12 V
1 2
2
2
1
1
DSR
DCD
DTR
DB9-6
NOTE: JUMPERS J8, J9 AND J10 RELATE TO
THE P6 CO NNECTOR. JUMPERS J5, J6 AND J7
RELATE TO THE P5 CONNECTOR.
J6 AND J8
J5 AND J9
J7 AND J10
DB9-1
DB9-4
DB9-5
1 2
J19 AND J20
CAUTION
Remove a module from its assigned slot before installing or
removing a cable assigned to that slot. Failure to do so could
result in damage to the module.
ATTENTION
Avant de retirer ou de brancher un câble, retirez le module logé
dans la coulisse correspondante. Autrement, le module risque
d'être endommagé.