Baicells Neutrino-224, Installation Manual

Page: 19 / 86

19
a. IP address is 192.168.150.xxx (where xxx is a number from 100 to 254).
b. Subnet mask is 255.255.255.0 .
c. Default gateway is 192.168.150.1 .
7. In the command window, execute a ping to 192.168.150.1, and check whether the
connection between the client computer and the eNB is working.
4.6.3 eNB GUI
NOTE: The eNB GUI menus vary according to software version and based on FDD or
TDD operation. Both FDD and TDD GUIs are covered in this document.
Once you have connected a computer to the LAN port, open a Web browser and go to
http://192.168.150.1 . Log in using username admin , password admin (Figure 4-6).
Figure 4-6: eNB GUI Login
This will open the eNB GUI home page (FDD shown in Figure 4-7, TDD shown in Figure 4-8).
Go to BTS Info > Basic Info > Cell Status to check the cell (eNB) status (the field highlighted in
red in the figures. The
Cell Status field should indicate Activation (for Active). You are ready to
go to the next step – section 5 Configuration.
If the status is reported as inactive, check the SCTP/S1AP link or contact Baicells support .