15
4
Mounting the Unit
This section covers how to install the Neutrino eNodeB (eNB) on a ceiling or wall. If you
completed the steps in
section 3
Verify Basic Operation, as recommended, uninstall the power
connections from the eNB before installing the unit on a ceiling or wall.
4.1 Preparation
If you plan to install the Neutrino eNodeB (eNB) on a ceiling or wall, you will need a marker
pencil and a percussion drill to install the bracket that holds the eNB. Go to
section 4.2
for a
ceiling installation, or to
section 4.3
for a wall installation.
Some operators may want to add a GPS antenna to ensure accurate physical location
information used by the eNB during transmissions. To connect the antenna you will use the
GPS interface on the eNB. Follow the GPS vendor’s installation requirements to install a GPS
antenna with the Baicells Neutrino-224 eNB.
4.2 Ceiling Installation
Review the following guidelines for installing the Neutrino-224 eNB unit on a ceiling. The
installation steps follow.
The thickness of the ceiling should be no less than ½ inch/18 mm, and should be able to
bear more than 11 lbs/5 kg weight.
If the ceiling is made of weak materials, such as a gypsum, this installation method is not
recommended. Because of the environment restrictions, to continue with a ceiling mount
in this situation add one layer of stronger panel under the screws to make sure the device
is secure.
1.
Attach the bracket under the Neutrino eNB unit using the M3*10 cross round head screws
(Figure 4-1).
Figure 4-1: Attach Bracket
2.
Remove the selected ceiling panel.
Summary of Contents for Neutrino-224
Page 1: ...Neutrino 224 Indoor 2x125mW FDD TDD eNodeB Installation Guide December 2018 Version 1 7...
Page 20: ...20 Figure 4 7 FDD eNB GUI Home Page Figure 4 8 TDD eNB GUI Home Page...
Page 47: ...47 Figure 5 24 LTE Neigh Freq Settings 1 of 2 Figure 5 25 LTE Neigh Freq Settings 2 of 2...
Page 64: ...64 Figure 5 38 Cell ReSelection Parameter Figure 5 39 Additional Measurement Parameter...
