DVG-G1402S Configuration for GOtalk
In the following guide we will cover all of the settings required to configure your DVG-G1402S with your
GOtalk VoIP Account.
Factory Reset
It is recommended to factory reset your router before we proceed with the correct settings to ensure that
all the settings that we enter are stored correctly. To factory reset the unit power on the unit and wait for
it to be in a system idle state (about 30-40 seconds after power on) then press and hold the Factory Reset
button. Continue to hold the Factory Reset button for 10-15 seconds then release; this will then restart
the unit In a Factory Default state.
Reset Button is shown above by the red arrow
Accessing the Web Interface
Now to configure your unit from scratch we will need to connect to the interface via a Web Browser. Any
browser will be fine but for this guide we will be using Internet Explorer 6.0 (IE6). To log into the router
open up IE6 and type “
” into the address bar. This will now prompt you for a
username and password to configure the DVG-G1402S as shown below:
Username: “admin”, Password: “admin”
You will now need to enter the username and password to access the device. The username will be
“admin” and the password is also “admin”. Once you have entered the username and password press the
OK button.
Summary of Contents for DVG-G1402S - Wireless Broadband VoIP Router
Page 4: ......
