![background image](http://html2.mh-extra.com/html/baby-lock/enterprise-bnt10l/enterprise-bnt10l_instruction-and-reference-manual_3203890292.webp)
APPENDIX
————————————————————————————————————————————————————————————————————————————
290
The embroidery
pattern is
misaligned.
The embroidery frame is not
correctly attached to the
carriage.
Correctly attach the
embroidery frame to the
carriage. Make sure that the
pins on the left and right arms
of the embroidery frame holder
securely fit into the holes in the
handles on the embroidery
frame.
p.51
The carriage or the embroidery
frame is hitting objects.
The pattern may become
misaligned if the carriage or
embroidery frame is hitting
objects. Make sure that there
are no objects within the
operating field of the
embroidery frame.
The fabric is caught or pinched.
Stop the machine, and then
correctly position the fabric.
The carriage moved while
removing embroidery frame.
The pattern may become
misaligned if the presser foot
was hit or the carriage was
moved while replacing bobbin
thread, changing needle, or
working near embroidery
frame.
Be careful when removing and
reattaching the embroidery
frame while replacing bobbin
thread, changing needle, or
working near embroidery
frame.
If the carriage is moved, turn
the machine off, then on again.
The correct frame position at
the time that the machine was
stopped is stored in the
machine’s memory, and the
embroidery frame is returned to
the correct position.
The design was not digitized
correctly.
The design may need more pull
compensation or underlay to
accommodate stretchy or high-
napped fabrics.
There are loops in
the upper thread.
The upper thread tension is low.
After passing the upper thread
through the hole in the presser
foot, pull the thread by hand to
check the thread tension. If it is
difficult to determine, compare
it with other needle bars where
looping does not occur.
p.123
The thread tension does not
correspond to the amount that
the thread tension knob was
tightened.
If the thread tension cannot be
adjusted, thread wax and dust
may have collected in the
upper or middle thread guide
plates, causing the thread
tension guide plates to rise.
Clean the thread tension guide
plates.
p.280
Symptom
Probable Cause
Remedy
Reference Page
Summary of Contents for Enterprise BNT10L
