127
Chapter 17. DISPOSAL
When discarding, please remove the internal battery and dispose of the recorder and battery
properly, following local regulations.
Handling Precautions
・
Removing and replacing the battery may cause damage or malfunction. Except when discarding the recorder,
contact the azbil Group for battery removal/replacement.
Removing/replacing the battery
Remove the front pane.
1. Open the key case and remove the 2 screws
attaching the front pane to the case (main
unit).
2. To remove the front pane from the case, pull
the lower part of the pane toward you and
then slide it upward.
3. The front pane is connected to the circuit
boards in the case by 3 wires. Disconnect
them from the pane.
The front pane is
connected to circuit board A by 1 cable.
Disconnect this cable.
4. Circuit board A is connected by 3 cables.
Disconnect these 3 cables.
5. Remove the 4 screws holding circuit board A,
and draw out circuit
board A towards you.
6. Remove the screw that holds the mounting
bracket to the case.
7. Disconnect the wire on the side of the power
switch
on the left edge of circuit board C, and then
pull out
coupled circuit boards B and C.
8. Remove the 2 screws holding boards B and
C together,
and separate boards B and C.
9. The battery holder is installed on the rear side
of
circuit board B. Remove the lithium battery
from the
battery holder using a fine-tipped insulated
tool.
Mounting
bracket
Circuit
board B
Circuit
board A
Front
pane
Circuit
board C
Circuit
board A