Axminster Trade AT254SB, Original Instructions Manual

Page: 20 / 52

Initial Assembly
20
951539 10” and 12” Sliding Table Kits (Box 1 of 2) and (Box 2 of 2)
Locate and identify the mounting brackets (35) and
the height adjustor blocks (45). These are mounted
on the outside faces of the upper chassis legs. They
are anchored against clamping the plates (36) that
are behind the face of the legs.
NOTE: These clamping plates are ‘loose items’, each
is initially held in place by three M10 x 19mm hex
Line up the holes in the clamping plate in
ready ness for fitting mounting bracket
Mounting plate in position
Fig 62
Fig 63
Unscrew the caphead bolt until the
recessed hole is clear
Attaching the mounting bracket (35) to
the side of the saw bench (1)
Fig 64 Fig 65
36
45
35
Caphead bolt
Fit a bolt (39) through the bottom hole of the
bracket, screw it back into its position. Align the
adjustor block (45) as near vertical as you can
judge and fasten the caphead bolt.
Screw the adjusting caphead bolt back through the
block until it touches the lower face of the mounting
bracket (35). (See fig 66) Nip the securing bolts for
Mounting Bracket/Adjuster Block Assembly
bolts (39). Unscrew the caphead bolt in the height
adjustor block (45), see fig 64, until the recessed
hole for the caphead bolt (39) is clear, fit it through
the height adjustor block and screw it back into its
position. Screw it almost home. Next fit a caphead
bolt through the top hole of the bracket (35), and
with the bracket tilted to one side, screw it back into
its position. (See figs 62-63 and 65)
the mounting bracket. Fit the other bracket in the
same way. NOTE: When screwing the adjusting bolt
back through the block, set it to leave the brackets
at approximately the same height. (See fig 67)
Unscrew the slide rail assembly lift and shift handles
(A) so that the square clamps have plenty of
movement.