Axminster Trade AT254SB, Original Instructions Manual

Page: 12 / 52

Initial Assembly
12
Drive shaft for the tilt mechanism
Insert the hand wheel over the
shaft for the tilt mechanism
Fig 17
Fig 18
Secure the hand wheel in place using a
Hex screw and washer then tighten using
the supplied Hex key
Fig 19
Key slot
Key slot
Shaft
Square key
Hex screw
Fig 21
Fig 22
Fig 20
10
14
Saw Guard Assembly
Locate the Riving Knife (14), remove the 5 screws
that secure the saw gullet, place both carefully aside.
(See figs 21 22) Raise the saw blade up to its highest
point.
NOTE: The mounting plate for the riving knife
has been factory set to ensure that the riving
knife is aligned with the blade. DO NOT alter
the setting bolts.
Locate the two hand wheels (10). Remove the Hex
screw and washer from both drive shafts and place
aside. Insert a square key into each machined slot
on the drive shafts and slide the hand wheels onto
the shafts. Replace the Hex screws and washers and
tighten securely , (See figs 17-18-19-20)
NOTE: Line up the key slot in the hand wheel with
the square key and slide the wheel onto the shaft,
tighten securely.
NOTE. Please ensure that the rise and fall LOCK is
unlocked before operating the mechanism.
Fitting Hand Wheels