Axminster Trade AT254SB, Original Instructions Manual

Page: 18 / 52

Initial Assembly
18
Locate the long Rip Fence (front rail) (32) and (back
rail) (33), remove the short rip fence front and
back rails (22-23) from the saw bench (1), (follow
the instruction on pages 14 and 15, “Rip Fence
Assembly” to assemble the long rip fence rails.
NOTE: Make sure the both rip fence rails are parallel
to the far left of the left extension table (26), (See fig
52). Replace the rip fence assembly (20) on the saw
bench (1), as described on page 15.
501196 10” and 501197 12”
Table Extension Kits (Box 2 of 2)
The left extension table, with both
fence rails parallel to the edge.
Table Extension Kit, (Setup 1) assembled
Fig 52
Fig 53
Setup 2
Fig 54
Fig 55
26
The Left extension table (26) can be
repositioned to the end of the right
extension table to create a large
surface area, in doing so it also free’s
up the space to attach the sliding table assembly
(code no: 951539).
Locate the table support leg (27), the threaded
rubber foot (28) and two M8 x 20mm hex bolts,
washers and nuts (31).
Line up the two middle holes to outside edge of the
table with the pre-drilled holes in the support leg
bracket (27) and fasten securely using the M8 bolts,
washers and nuts. (See figs 55-56)
26
27
First remove the rip fence assembly (20) and place
safely aside, loosen both rip fence rails (32-33) and
slide them to the right. Undo the four M8 x 30mm
hex bolts and remove the left table. Attach the left
table to the right table using the four M8 x 30mm
bolts,washers and nuts as before, (WARNING:
YOU MUST ENSURE THAT THE NUTS IS FULLY
ENGAGED ON THE BOLTS BY SERVERAL TURNS,
BEFORE RELAXING THE LIFTING EFFORT). Tighten
all the bolts securely. (See fig 54)