Axminster Trade AT254SB, Original Instructions Manual

Page: 15 / 52

Initial Assembly
15
Locate the capping plates for the front rail (24B) and using the self tapping screws (24C), secure
in place. (See fig 35) Set the front rail in position, remembering that it must be slightly inside
the front left hand edge of the main saw table, so that the sliding table does not collide with it.
Tighten ONLY the 3 bolts in the main saw table. Repeat the process for the back rail.
Fig 35
Fig 36
Locate the Rip Fence assembly (20), fit the rip fence assembly to the saw by ensuring the
clamping lug at the rear of the fence is hooked over the back rail (23), lower the fence and
manoeuvre the bracket over the front guide rail (22). (See fig 36)
Micro-Adjuster Assembly
Tighten the Phillips screws securely
Fig 37
Fig 38
Locate the Micro-Adjustor (25) there are two Phillips screws through the adjustor
mounting bracket with square nuts on them. Ensure the nuts are undone sufficiently to allow
them to slide into the channel in the Rip Fence mounting bracket, position as required, normally
slightly to the right of the rip fence, (See figs 37-38) and tighten the screws securely.
25
20
22
Capping plate
Fig 39
Fig 40
Locate the capping plates for the Rip Fence Mounting Bracket (24A) and fit carefully using the self
tapping screws. (See figs 39-40)
24A
24B
24C