Axminster Trade AT254SB, Original Instructions Manual

Page: 22 / 52

Initial Assembly
22
Locate the sliding table assembly (38) and manoeuvre the bearing bogies onto the rails (40),
slide the table onto the rails and position it safely within the boundary of the table. (See fig 73)
Ensure that the initial setting of the slide rail assembly will not cause the sliding table (38) to
collide with the main table (1). Replace the buffer ring (B) and the safety stop.
Locate the capping plates (C) for sliding rail
and clip them in place
Slide the table onto the rails and position it
safely within the boundary of the table.
Fig 72
Fig 73
C
Mitre Angle Rip Fence Assembly
Locate the mitre angle rip fence assembly and mitre angle rip Fence (44). Remove the
clamping handle and washer from the mitre angle rip fence assembly and place safely aside.
Undo the two caphead bolts from the sliding table assembly (38) and bolt the mitre angle rear
quadrant (42) to the table. (See figs 74-75)
Fig 74
Fig 75
Fig 76
Fig 77
Loosen the two caphead bolts on the table fence mounting casting (43), allowing sufficient
movement to be able to be slid into the extrusion in the rear of the fence. introduce the square
clamps into the main channel in the extrusion on the fence (44), leave the caphead bolts loose at
this time.(See fig 76).
38
42
43
44
38