Axminster Trade AT254SB, Original Instructions Manual

Page: 17 / 52

Initial Assembly
17
951538 10” and 951541 12”
Table Extension Kits (Box 1 of 2)
Select one of the extension tables (26), locate four
M8 x 30mm hexhead bolts and washers (30). Ensure
the table is correctly orientated (the front edge of
the table is bevelled). Stand the back end of the
table on the floor, close to the front and edge of the
main saw table (1), with the underside of the table
facing the front of the saw. Lift the table up and
introduce a washered bolt through the first hole in
the table and screw it into the first threaded hole
along the main table edge.
Fig 50
Fig 51
Screw the bolt in until it is almost home. You can
now relax the lifting effort. The extension will hang
pivoted on the bolt. Carefully lift the bottom end
of the extension up until the edges are level and
introduce a bolt and washer through the rear hole
and the last threaded hole in the table edge, screw
Setup 1
Fig 48
30
Fig 49
26
Continues Over...
WARNING!! THE EXTENSION TABLES
ARE VERY HEAVY YOU WILL REQUIRE A
SECOND PERSION TO HELP!
it almost home. The extension should be hanging
approximately in its correct position held by the
two bolts. Introduce and almost screw home the
other two bolts and washers. Using a level, align the
top and front edges at the front of the saw, nip the
front bolt to hold the extension in place; carefully
manoeuvre the rear of the extension to align the
two top edges and ‘nip’ the rear bolt.
Check this movement has not disturbed the
alignment at the front of the table, if it has, repeat
the procedure until the front and top edges are
aligned. Tightened all the bolts securely. (See figs
48-49-50 and 51) Repeat using the other extension
table (26) for the opposite side of the saw bench (1).