3 Installation der FRITZ!Card – Windows 3.x
26
3.3.1 Changing the Settings in the Software
Changing the D channel protocol and data compression
If you wish to subsequently change the D channel protocol or
the settings for data compression, run the installation program
for
FRITZ!Card
again.
Changing the I/O address and the interrupt in the software
If you wish to subsequently change the value for the I/O ad-
dress or the interrupt in the software, start the
FRITZ!Card Setup
program in the
AVM
program group
.
The following input mask
appears:
Fig. 3
Input Mask
All available I/O addresses and interrupt values are displayed
in the dialog box when you click on the small arrows. Enter the
value for the I/O address in the upper box. Select the value which
you have set by positioning the jumper directly on the card.
Enter the interrupt in the lower dialog box.
Click on
OK
to save your settings. You must restart the com-
puter for the changes to take effect.
Summary of Contents for FRITZ!CARD Classic
Page 35: ...5 FRITZ Installation 35 ...
