3 Installation der FRITZ!Card – Windows 3.x
23
3.3 Installation in Windows 3.x
You have the facility to install
FRITZ!Card
with the aid of the
introduction contained on the CD. This introduction guides you
through the installation procedure and gives you installation
instructions.
Start the CD introduction by going into the File Manager and
double-clicking on the file INTRO.HLP in the root directory of
the
FRITZ!Card
CD.
FRITZ!Card
is installed on your computer by means of a detailed
installation program. Installation is performed in four main
steps:
1.
Setting the I/O address on
FRITZ!Card
2.
Installation of
FRITZ!Card
in the PC
3.
Connection of
FRITZ!Card
to the ISDN
4.
Installation of the driver software for
FRITZ!Card
With Windows 3.x it is absolutely essential to observe the sequence
of the installation steps. If you fail to follow the specified sequence,
error-free operation of FRITZ!Card is not guaranteed.
The procedure for installing
FRITZ!Card
is as follows:
1. Setting the I/O Address on FRITZ!Card
• In the first step of installation before installing
FRITZ!Card
in your computer, make sure that a free interrupt and a free
I/O address are available. To this end, call up a diagnostic
program by going into DOS and entering C:\MSD. In the next
window you will see a listing of the interrupts which are al-
ready in use.
• If you wish to use an I/O address for
FRITZ!Card
which devi-
ates from the preset value on the card, it is necessary to
change the jumper position directly on the card. For how to
change the jumper position, see Chapter 6 “Setting the I/O
Area (I/O Address) on FRITZ!Card”.
Summary of Contents for FRITZ!CARD Classic
Page 35: ...5 FRITZ Installation 35 ...
