3 Installation der FRITZ!Card – Windows NT
19
3.2 Installation in Windows NT 4.0 (Workstation i386)
You have the facility to install
FRITZ!Card
with the aid of the
introduction contained on the CD. This introduction guides you
through the installation procedure and gives you installation
instructions.
Start the CD introduction by going into the Explorer and double-
clicking on the file INTRO.HLP in the root directory of the
FRITZ!Card
CD.
To install the driver software for FRITZ!Card in Windows NT 4.0, you
must have administrator rights.
Note that before installing the FRITZ!Card driver software, it is abso-
lutely essential that you install the current Microsoft Service Pack on
your computer. You can obtain this software directly from Microsoft.
FRITZ!Card
is installed on your computer by means of a detailed
installation program. Installation is performed in four main
steps:
1.
Setting the I/O area (I/O address) on
FRITZ!Card
2.
Installation of
FRITZ!Card
in the PC
3.
Connection of
FRITZ!Card
to the ISDN
4.
Installation of the driver software for
FRITZ!Card
With Windows NT it is absolutely essential to observe the sequence
of the installation steps. If you fail to follow the specified sequence,
error-free operation of FRITZ!Card is not guaranteed.
The procedure for installing
FRITZ!Card
is as follows:
1. Setting the I/O Area (I/O Address) on FRITZ!Card
• In the first step of installation before installing
FRITZ!Card
in your computer, make sure that a free interrupt and a free
I/O area (I/O address) are available.
• FRITZ!Card is set to 5 for the interrupt and to 300 for the I/O
area. If you wish to use an I/O area for
FRITZ!Card
which
deviates from the preset value on the card, it is necessary to
Summary of Contents for FRITZ!CARD Classic
Page 35: ...5 FRITZ Installation 35 ...
