AVM FRITZ!CARD Classic, Manual

Page: 20 / 37

3 Installation der FRITZ!Card – Windows NT
20
change the jumper position directly on the card. For how to
change the jumper position, see Chapter 6 “Setting the I/O
Area (I/O Address) on FRITZ!Card”.
2. Installing FRITZ!Card in the PC
• After checking and, if necessary, changing the jumper posi-
tion on FRITZ!Card , installation of FRITZ!Card is now car-
ried out. Before performing the installation, switch off the
PC and all other connected units and pull out the power
plugs.
• Loosen the screws of the PC housing and open the PC.
• Select an appropriate slot, remove the slot plate on the top
end and insert
FRITZ!Card
into the selected slot.
• Screw FRITZ!Card tightly to the top end of the slot.
• Close the computer, tighten the screws and reconnect the
power plugs. The installation of
FRITZ!Card
is now com-
pleted.
3. Connecting FRITZ!Card to ISDN
• FRITZ!Card must now be connected to the ISDN. Take the
cable supplied with the card and insert the plug into the
FRITZ!Card socket.
• Simply insert the other end of the cable into the ISDN socket.
4. Installing the FRITZ!Card Driver Software
Once
FRITZ!Card
has been installed in the PC and connected to
ISDN, the next step is to install the
FRITZ!Card
driver software.
• Insert the FRITZ!Card CD into your CD drive.
• Start the introduction by double-clicking on the file
INTRO.HLP in the root directory on the CD.
• On the welcome page of the introduction, click on the icon
for FRITZ!Card and on the next page, click on the Windows
NT icon.