Opening and Closing the Media Drive Drawers
46
11. Secure the rear stabilizer brackets to the rear rackmount rails through top and bottom holes
in the extender bracket as shown in the preceding figure using the screws included in the
rack mount kit or your rack screws.
12. Snap the left and right plastic covers over the plastic end caps on the front Engine as shown
in the preceding figure.
Opening and Closing the Media Drive Drawers
This section covers how to open the media drive drawer and replace a media drive. The
procedure is the same for both drawer 1 and drawer 2.
w
To ensure the stability of the rack enclosure, The Engine includes a mechanism that only
allows one drawer to be open at a time. If both drawers were open at the same time, there is
a risk that the rack could tip.
To open a drive drawer:
1. Make sure the anti-tamper locks are not engaged. The red arrows on the locks will point
inwards if the locks are disengaged. Unlock them if necessary by rotating them
counterclockwise using a screwdriver with a Torx T20 bit.
2. Push the drawer latches inward and hold them.
3. Slowly pull the drawer all the way out until it locks open.
Summary of Contents for ISIS 2000
Page 1: ...Avid ISIS 2000 Setup Guide...
