Rack-Mounting the Equipment
44
4. Secure the bracket rail to the front and rear mounting rails using either the screws that come
with the rack mount kit of your rack screws (five screws in the front and the rear).
n
Leave the top most holes on the front of the rail empty so you can use those holes to screw
through the ears on the Engine to keep it from sliding forward once racked.
5. Tighten the four slide adjustment screws.
6. Repeat steps 1 through 5 to install the other bracket rail on the opposite side of the rack.
7. Make sure that the media drives are not installed in the Engine.
8. Using two people, lift the Engine and place the rear of the Engine onto the brackets as shown
in the following figure.
9. Position the bracket extender on the outside of the rear mounting rail so that the sliding nut
in the bracket extender inserts into the rack mounting tab on the Engine. Using the short
screws included in the rack mount kit, secure the bracket extender to the rack mounting tab
on the Engine as shown in the following figure.
The rack mount kit provides two sets of bracket extenders: a long pair and short pair. Use the
pair of bracket extenders that are most appropriate for your rack. Racks with less depth,
would need the longer bracket extenders.
Summary of Contents for ISIS 2000
Page 1: ...Avid ISIS 2000 Setup Guide...
