Engine
23
Release latch
Power OK
Power supply fault
AC fault
Power Switch
Engine Power Supply Panel
Component
Description
Release Latch
Displays the unit number assigned to the Engine. When a signal is sent
from the software, the ID number blinks to identify the Engine. This
helps locate the Engine when it is installed in a high-density rack/cabinet
populated with several other similar systems.
Power Supply Fault Indicator
Illuminates amber when an error is detected with the system. The
following are possible faults.
•
On: with single beep, then double beep — power on test state.
•
On: any power supply, voltage, fan, module, or temperature (over or
under) fault
•
Flashing: logical fault — unknown, invalid, or mixed module type
installed, bus failure (inter communication failure), or EBOD VPD
configuration error.
•
On: Drive failure causing loss of availability or redundancy
•
Flashing: when both the Module Fault and Logical Status LEDs are
flashing, the unit ID number is different from “Start of Day.”
AC Input Fault Indicator
Flashes amber when arrays are performing a background function. When
both the Module Fault and Logical Status LEDs are flashing, the unit ID
number is different from “Start of Day.”
Power on / Standby Indicator
Illuminates green when the power is on. A power switch is located on
each of the two power supplies on the back of the Engine.
Power Switch
Press to power on the enclosure.
Summary of Contents for ISIS 2000
Page 1: ...Avid ISIS 2000 Setup Guide...
