Avery Berkel CX20 SERIES, Service Manual

Page: 104 / 353

9 — Label Formats
9–13 CX20/CX30/CX34 Service Manual
9.3.2 Determining the label field co–ordinates
At the bottom left–hand corner of the label mark the position of the start point –
for a 90
°
or 180
°
label its position needs to be offset, see Section 9.2.5. Draw
the X and Y axes through the start point. For each field obtain x1, y1, x2 and y2
by measuring the distances from start point to both co–ordinates in the X and Y
planes (see Section 9.2.3).
Convert x1, y1, x2 and y2 values to co–ordinates, X1,Y1 and X2,Y2, using the
conversion factors in Table 9.2.
9.3.3 Programming
The details of the new label format have to be programmed into the machine,
this is done in the EDIT FORMAT option – see Section 9.4.
After selecting the required format number for editing, the new label format can
be programmed. This involves the entry of two co–ordinates and, depending on
type of field, text font and a reference number. This is done for each field in
sequence until ENTRY ACCEPTED is displayed, indicating that your new label
format has been programmed and accepted by the machine.