Owner Installation Instructions
GDO-10V2L2 Toro
™
5
The garage door must be
well balanced.
Sticking or binding doors must be repaired by a qualifi ed garage door
installer prior to installation of the opener.
Frequently examine the installation for signs of wear, damage or imbalance.
DO NOT
use if repair or
adjustment is needed since a fault in the installation or an incorrectly balanced door may cause injury.
DO
NOT
attempt to repair the door yourself as hardware is under extreme tension.
Remove or disengage
all garage door locks and mechanisms prior to installation of the opener.
Connect the opener to a properly
earthed
general purpose 240V mains power outlet installed by a
qualifi ed electrical contractor.
Disconnect the power cord
from mains power and backup batteries before making any repairs
or removing covers. Only
experienced
service personnel should remove covers from the
opener.
When using Auto-Close mode, a
Safety Beam
must be fi tted correctly and tested for
operation at regular intervals.
Extreme caution
is recommended when using Auto-
Close mode.
All safety rules
must be followed.
In order for the opener to
sense
an object obstructing the door way, some
force
must be exerted on the object. As a result the object, door and/or person may
suffer
damage
or
injury.
If the power supply cord is damaged, it
must
be replaced by an Automatic
Technology service agent or garage door professional.
Make sure that the door is fully open before driving in or out of the
garage and fully closed before leaving the driveway.
Make sure that remote controls are kept out of reach of children.
Install the wall transmitter in a location where the garage door
is visible, at a height of at least 1.5m, out of the reach of
children.
Important Safety Instructions
