14
GDO-10V2L2 Toro
™
Owner Installation Instructions
ock Kit Installation Instructions
RED
BLACK
RED
BLACK
RED
BLACK
BLACK
09
fi g
10
fi g
11
fi g
STRUCTIONS | OWNERS COPY
Safety Beams Installation
Step 5 - Safety Beams
Safety
Beams
extend across the garage door opening.
The
Safety Beam
is designed to detect an obstruction
while the door is closing and to send a signal to the
garage door opener to reverse or stop
the door
movement. One, two or three sets of Safety Beams can
be connected to
GDO10V2L2 opener.
Step 5.1 - Fitting the Safety Beam
Attach the mounting bracket (4) to the adjustment
bracket (3) with the pan head screw (6) (supplied).
(Fig. 09)
Attach the bracket (2) to the Safety Beam
transmitter with four taptite screws (m3x5) and
attach the other side to the adjustment bracket (3)
with the pan head screw (6) .
(Fig. 10)
Repeat steps a and b to assemble the Safety Beam
receiver.
Locate the Safety Beam in a strategic location in the
doorway. Automatic Technology recommend that the
sensor is placed 100mm above the fl oor level and as
close as possible to the door opening. Connect as per
the wiring diagram
(Fig. 11)
.
Step 5.2 - Alignment
Power up the GDO10V2L2 with the
Safety Beam
connected. The green LED on the transmitter
should turn ON to indicate power is present.
If the receiver is connected to power and the
red LED is fl ashing while the green LED on the
transmitter is on, the transmitter and receiver are
not aligned.
Make horizontal and/or vertical adjustment on the
transmitter and/or receiver until the red LED on the
receiver turns on, indicating alignment.
NOTE: The sensors need to be 100mm above
the fl our level however, The exact position
must be chosen in such a manner that it suits
the application, the environmental conditions
and provides maximum safety protection.
WARNING: Install the Safety Beam as per
diagram in (Fig. 03). Tampering with the Safety
Beam could result in serious personal injury
and/or property damage and will void the
warranty.
WARNING: Safety Beam must be installed if
the closing force as measured at the bottom
edge of the door exceeds 400N (40kg).
NOTE:
Three wire safety beam is not compatible with
GDO-10V2L2 opener.
a.
b.
c.
a.
b.
c.
1
2
3
4
6
6
