Owner Installation Instructions
GDO-10V2L2 Toro
™
13
Step 3 - Mounting The Opener
If the internal gear does not rotate freely, switch the
opener to manual by pulling the disengagement
handle down (there will be a click), so the ring gear
can be rotated by hand.
Slide the opener over the door axle and into the
drum of the door
(Fig. 07)
.
Ensure the internal gear is pushed in as far as
possible (without interfering with the door curtain)
and that all of the door drum’s wheel spokes are
completely between the opener’s drive forks.
Re-attach the door bracket using your reference
marks as a guide and tighten the bolts. Ensure that
the slots in the mounting bracket of the opener
align with the slots in the door bracket, otherwise
the door bracket may have to be relocated. If the
bracket cannot be relocated, the opener may be
fi tted onto the axle using the opener’s saddle and
bolts as follows:
Using your reference marks as a guide,
sit the opener on the door mounting
bracket and secure with the opener’s
bolts and saddle and tighten fi rmly
(Fig.
08)
.
Adjust the door position (if necessary)
on the brackets so that the door feeds
smoothly into the guides. Make sure that
the centre of the door doesn’t hit the
lintel and that the curtain is not pushed
forward hard into the guide.
Remove the support and safety ropes.
IMPORTANT NOTE - If the manual release
handle is more than 1.8 metres from fl oor level
when the opener is installed, extend the handle
to a height less than 1.8 metres.
Step 4 - Installing The Wall Mounted Control
Unit
Remove the face cover from the wall mount
control unit.
Affi x the wall mount control unit at a height of
1.5 metres within sight of the door but away
from moving parts. Make sure this location of the
wall control unit is out of reach of children and
convenient to the customer
.
Replace the face cover.
Connect the network cable from the wall control
unit to the
GDO-10V2L2
powerhead unit and
secure with p clips (supplied).
Connect the power cord to a suitable power
point, but
DO NOT SWITCH ON
.
Secure the
power cord away from any moving object (e.g.
the door) with the cable clips.
With the opener still disengaged, pull the door
up and down to make sure it runs freely.
a.
b.
c.
d.
i.
ii.
e.
a.
b.
c.
d.
e.
f.
07
fi g
08
fi g
Installation
Tighten Nuts
