+
Press and hold
the
*
and #
buttons until
the lights on the
keypad stop
blinking.
1
2
Enter a 4-digit
personal
identification
number (PIN)
of your choice:
3
4
Press 0 to
complete the
programming.
5
The garage door
opener will activate.
6
? ? ? ?
? ? ? ?
PROGRAM INITIAL PIN
CHANGE AN EXISTING PIN*
PIN
Press and release the ENTER
button...
1
? ? ? ?
Press the programmed PIN
that you want to change.
...the light bulb blinks twice.
2
Press and hold the
# button until...
3
+
? ? ? ?
new PIN
Enter the new 4-digit PIN of your choice,
then press the ENTER button.
To test, press the PIN, then press the ENTER button.
4
To test, press the new PIN,
then the ENTER button.
The garage door opener
will activate.
The light bulb will blink once.
Check to see if the
light bulb blinks.
If not, slowly press
and release the
ENTER button until
the light bulb blinks.
Be careful NOT to
press the ENTER button after
the light bulb blinks.
Press and
release the
Learn button.
The LED will light.
Within 30 seconds...
PREPARE
Locate the Learn button on the garage door
opener.
NOTE:
Your garage door opener may
look different.
Learn
LED
Learn
LED
OR
OR
Learn
LED
Green
or
Red/Orange
Purple
Yellow
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and
away from ALL moving parts of door.
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
* For garage door openers that have a green Learn button or an external receiver repeat "Program Initial PIN" to change the existing PIN.
To program the Keyless Entry to more than one garage door opener, repeat the steps above using a new PIN for each additional garage door opener.
WIRELESS KEYLESS ENTRY
•
MODEL 139.3050
Compatible with 315 MHz or 390 MHz garage door openers
manufactured after January 1, 1993. Make sure the garage door
opener has a working light bulb because it is a programming
indicator.
Refer to your product manual for the location of the Learn button.
Install the battery and program the Keyless Entry prior to
installation.
