9
I NSTALLATION
5. FIXING DRIVE UNIT TO THE DOOR
(RIGHT HAND INSTALLATION)
The Automatic Openers Drive Unit can be fixed to the
Roll Up Garage Door in a variety of ways. Below we will
describe one method of fixing. Make sure there is enough
side room (135mm from end of door shaft to the wall) to
slide Drive Unit onto shaft.
PLEASE NOTE
: THE INSTRUCTIONS FOR
FIXING OF THE DRIVE ASSEMBLY TO THE
DOOR IS FOR RIGHT HAND INSTALLATION.
FITTING DRIVE UNIT TO DOOR
( Fig. 6, Fig. 7, and Fig. 8 ).
1. Check that the door shaft U bolt is securely
tightened on the left hand side of the door.
2. Raise the door and tie a rope around the centre
to secure the roll.
3. Support the right hand end of the door with a
suitable prop, e.g. step ladder and soft padding
to protect door surface.
STOP.
WARNING:
DO NOT ALLOW CHILDREN/
PERSONS AROUND THE DOOR AND PROP.
SERIOUS PERSONAL INJURY AND / OR PROP-
ERTY DAMAGE CAN RESULT FROM FAILURE TO
FOLLOW THIS WARNING.
4. Check that Step 3. was completed. Carefully
loosen and remove the right hand door shaft U bolt.
5. Make sure that the door supporting prop is
secure. While the door is supported remove the
right hand door mounting bracket from wall.
6. Remove the Drive Unit from packaging.
Try and rotate the drive gear by pushing on the
fork. If the gear does not rotate the manual
mode has to be selected. To select pull on the
string handle downwards, then release slowly.
The drive gear should now rotate. (Fig 13).
7. Slide the Drive Unit over the door axle making sure
that the fork extends into and over one of the spokes
of the door drum wheel.
8. Refit the door mounting bracket to the wall.
In some cases the bracket may have to be
re-positioned. Re-tighten the door shaft U bolt.
Remove door supporting prop and untie rope
from curtain.
9. Straighten the Drive Unit and position as per
Fig. 8. Tighten the two locking bolts firmly to
secure the Drive Unit.
10. Check the manual operation of the door by raising
and lowering the door. The door should run
smoothly and not catch on any part of the Drive Unit
11. Plug the connecting wire from the control box into
the bottom of the drive unit (Fig 8).
FIG. 8
FIG. 7
FIG. 6
