I NSTALLATION
13. FITTING OF SAFETY PHOTO
ELECTRIC BEAM (OPTIONAL)
Locate the Photo Electric Beam (P.E.) normally closed
contact type in a strategic location within doorway. Re-
move shunt from P.E connector (Fig.23) and connect the
plug from the P.E. wiring harness to P.E. connector
(Fif.24). Follow the wiring diagram supplied with the
P.E. for wiring of the P.E.
WARNING; When using auto close and P.E. beams, the
doorway must be clear of all obstructions and persons at
all times. The location of the beam and manner in which
it is installed might not give safety protection at all
times. Check to make sure that the height of the beam
and type used give maximum protection possible.
14. SETTING OF AUTO CLOSE TIME
IMPORTANT NOTE:
IT IS COMPULSORY TO INSTALL
A PHOTO
ELECTRIC BEAM BEFORE USING THE AUTO
CLOSE MODE.
The Auto Close timer will only start after the Photo Elec-
tric Beams (P.E.) path is broken and the auto close time
has been set. If the P.E. path is not broken the door will
remain open till the path is broken. If the Door Opener in-
curs an obstruction (not from the P.E.) while closing the
door will re-open and not auto close.
After the setting of the auto close mode, whenever the
door is in the open position the open limit green LED will
flash to indicate that the auto close mode is in operation.
SETTING AUTO CLOSE TIME
1. Press in and hold the Auto Close Time button 6
(Fig. 25).
2. While holding in the Auto Close Time button, press
the green Open button 3 (FIG. 25). Each press of
this button will add 5 seconds to the preset auto close
time of „0„ seconds.( 0 seconds = “OFF”)
3. To decrease the time follow step 1 and press the red
Close button 8. Each press will deduct 5 seconds
from the auto close time.
4. Press the O/S/C button 4 (Fig. 25) or Transmitter
to open the door. While the door is opening break the
path of the P.E. Beam, this will initialise the auto
close mode. When the door reaches the fully opened
position, the door will pause for the set auto close time
and start to auto close.
16
FIG. 23
FIG. 24
FIG. 25
