10. SETTING THE TRANSMITTER TO
OPERATE THE COURTESY LIGHT
The Transmitter can be programmed to operate the
Courtesy Light on the Door Opener.
1. Press and hold Light Code button 10 on the Control
Panel (Fig. 20).
2. Press the button on the Transmitter you would like to
use to control the light for approximately two seconds,
Pause for two seconds. Press the same button again
on the Transmitter for approximately two seconds.
3. Release the Light Code button 10.
4. Press the Transmitter button to see if it operates
the light.
11. DELETING PROGRAMMED CODES
11.1 DELETING A STORED TRANSMITTER CODE
1. Select the transmitter you want to delete.
2. Press and hold the blue Door Code button 9 ( Fig. 21)
on the Control Panel.
3. Press the Transmitter button you would like to delete
for two seconds. Pause for two seconds.
Press the Transmitter button again for two seconds.
4. Release the blue Door Code button 9. The code
should now be deleted. Confirm this by pressing the
transmitter button to see if it can operate the door. The
door should not respond.
11.2 DELETING ALL STORED TRANSMITTER
CODES
1. Turn the Power Off to the Drive Unit.
2. Press and hold the blue Door Code button 9 (Fig.21)
on the Control panel.
3. Turn the Power On again, while holding the Blue
Door Code button until the Coding LED illuminates.
(approx. 10 to 12 seconds)
Release the blue Door Code button 9. All the stored
codes including the Courtesy Light Codes should now
be deleted. Confirm this by trying to operate the door
by pressing one of the deleted transmitters.
12. SETTING OF COURTESY LIGHT
TIME
The preset courtesy light time on the Door Opener is
3 minutes. This time can be changed as below.
1. Press in together and hold the Auto Close Time but-
ton 6 and Force Margin Set button 1 (Fig. 22).
2. While holding in the two buttons, press the green
Open button 8 ( Fig. 22). Each press of this
button will add 10 seconds to the light time.
3. To decrease the time follow step 1 and press the red
Close button 8 (Fig. 22). Each press will deduct
10 seconds from the light time.
4. To recall the factory set default light time press in
and hold together the Auto Close Time button 6, the
Force Margin Set button 1 and the Reset button 5 for
about 2 seconds. (Fig. 22).
15
FIG. 21
FIG. 20
FIG. 22
I NSTALLATION
