AUTOCAR Xspotter 2014, Operator'S Manual

Page: 106 / 118

• Welding cables should not be allowed to lay
on, near or cross over any electrical wiring
or electronic component during the welding
procedure.
•
After finishing welding and the welded
areas have cooled, inspect wiring and
components for possible shorts or damage.
In the event of a short circuit, excessive
current will be drawn when the batteries are
reconnected, causing more damage to the
electrical system.
Electrical Center
The electrical system’s breaker and relay
boxes (referred to herein as “fuse boxes”) are
installed in various locations. Three fuse boxes
are located under the right side center arm
rest (Figure 132). The location of individual
components in these the fuse boxes is shown
on a label on the underside of the right side
armrest cover.
1 Fuse Box 2 (FB2)
2 Fuse Box 1 (FB1)
3 Main Circuit Breaker
4 Diagnostic Connector
Figure 132
877-973-3486 AWE 00054 Rev. 002 94
ACTT Xspotter Operator Manual